Plug and Charge Certificates

Root certificates which are currently loaded on the charger are listed under section "Loaded Root Certificates". These will be used to verify the connection to the EV and the SECC (Supply Equipment Charge Controller) certificate chain.

The certificate chain which identifies the SECC to the EV is listed under section "Loaded SECC Chain". The chain must be valid up to a loaded root certificate.

Management operations are possible in the section "Management". The result of the performed action will be displayed under section"Result".

• Reload Certificates: Reload all root certificates and the SECC chain from disk
• Renew SECC Chain: Trigger the renewal of the SECC chain via central system
• Verify loaded SECC Chain: Verify the loaded SECC chain against the available root certificates
• OCSP status check of SECC Chain: Request the validity of the SubCA certificates from the central system
• Create CSR: A new Certificate Signing Request will be created
• Clear all Root Certificates: All root certificates will be removed
• Clear SECC Chain: The SECC certificate chain will be removed
• Clear Result: Clear the result line
• Clear SECC Private Key Passphrase: Clear the passphrase of the encrypted SECC chain

Certificate data in PEM format can be uploaded to the charger under section"Certificate Upload". Use "Check" to only validate that the data is valid and "Apply" to actually store it in the charger. Make sure to select the correct certificate type.

Note: After the "Reload Certificates" action, the page must be manually refreshed.